Help needed for trailer bunk location

[Geno]

Hello everyone, I’m new to this jetboaters forum
But I sure can use some help. I have a 2006 Yamaha ar230 ho that came with the original
MFI trailer which is completely rusted out, so bad I had to leave my boat in Arizona because I was not able to tow back to California. I purchased a pacific galvanized trailer and I’m getting ready to go switch trailers but I would like to move the bunks and axles
Ahead of time if needed. If anyone has this trailer I would greatly appreciate it if you could get me some measurements. Looking for bunk locations
And measurements from back of bunk to center of tandem axle . Leaving this Friday so if your able to help I would appreciate it.

thank you
Geno

 

[Scottintexas]

glad to have you on board, sorry I can't help with the bunk location though,

be sure to check your scupper valve,

Scott

 

[Neutron]

Doubt that you will find someone with that trailer setup to get dimensions. Bring tools and eyeball it when you get there. Then trial and error unfortunately

 

[Geno]

Doubt that you will find someone with that trailer setup to get dimensions. Bring tools and eyeball it when you get there. Then trial and error unfortunately

Thanks, that’s exactly what I did! Brought her back home a couple of weeks ago. Thanks Geno